1320 97-01 CRV motor mount 68A 350hp RD1 CR-V-swapped engine 3 bolt post BLEMISH

1320 motor mount kit for 97-01 Honda CR-V RD1 chassis. Silver finish - 3bolt post mount. ITEM IS BRAND NEW BUT WILL HAVE MINOR SURFACE BLEMISH SUCH AS DINGS, SCRATCH PLEASE CHECK PICTURE FOR AN EXAMPLE OF THE BLEMISH. This mount kit is for crv with swapped integra engine since all integra b18b and b18c b18c1 also type R b18c5 use the 3 bolt post mount the standard 2 bolt motor mount from the b20 engine will not work this is where this 3 bolt mount kit comes in.

Design to work on all 3 bolt post mount engine swapped 97-01 Honda CRV with either automatic or manual transmission and will work on both 2wd or AWD. This mount kit is Specially made for the Honda CR-V not just a Generic EK motor mount. As you can see in the listing pictures the bracket for EK is taller and it will tilt the engine higher on the driver side when installed on to your CR-V and this could cause many issues such as axle angle, alignments, wheel hop, and less traction to one side of the wheel and more wear and tear on your vehicle. Kit come with all the necessary hardware for a smooth install. 68A stiffness up to 350HP please check our other listings for stiffer bushing to handle more power.

Bushing after break in period the vibration will calm down but it will still be stiffer than stock motor mounts. Please keep in mind that this is for Performance motor mount kit. It is strongly recommended that all installs be done by a mechanic or automotive specialist.

PLEASE MAKE SURE THIS KIT FITS YOUR VEHICLE BEFORE BOLTING THEM IN PLACE. 1320 Engine Mounts are built for performance driving. Although 1320 bushings are made to absorb engine vibration, you may still notice vibration depending on your engine's series and HP. 1320 Mounts removes the dampening oil containers harbored by OEM/Stock mounts.

By switching to stiffer mounts without the fluid reduces wheel hop and increases driving response.

---