Mumby Engineering Uprated Polyurethane MG Rover Engine Mount Steady Bushes. We design and develop bespoke and uprated automotive parts. All our products are rigorously tested to ensure they meet the high standards of quality and performance we strive towards. Feel assured you are dealing with a reliable and trustworthy ebayer, please view our good feedback. MG ZR/ZS/TD/105/120/160/180 - All engine steady mounts using the 56mm diameter section.
Rover 220/420 - Rear engine steady mount. Rover 620 - Top & bottom drivers side engine steady mounts.Please note the diameter of the hole these bushes are intended for is 56mm, please check your steel engine steady mount brace conforms to this to ensure fitment. Designed by us to do the job properly, this superior uprated polyurethane bush enhances and replaces the original standard rubber engine mount steady bush which tend to become perished and slack allowing your engine to jerk about under acceleration, an issue that often becomes significantly worse with tuned engines. As with all our products this kit has been thoroughly tested ensuring longevity of performance that will not let you down. Below circled in red are examples of mounts that will accommodate our uprated polyurethane bushes. Please note: This service is only achievable within the UK on orders placed between Monday-Thursday before 15:00. The item "Polyurethane Engine Mount Bush MG ZR/ZS/TD/120/160/180, Rover Turbo/K/T Series" is in sale since Monday, March 5, 2012. This item is in the category "Vehicle Parts & Accessories\Car Parts\Engines & Engine Parts\Engine Mounts". The seller is "mumby_engineering" and is located in Lincolnshire. This item can be shipped worldwide.